Click for original picture
Legal status confirmed
Brand:aa
Product detail:
1 This device has rapid, continuous and canned feeding and tapping system, and the maximum feeding capacity reaches to 20 tons per 24 hours. The efficiency is more than three times to the traditional Intermittent Operation Equipment.
2 The matching pressure release device is capable of increasing the value added of oil product to a large degree through deeply processing the oil product.
3 Manufacturing the whole set of device should be carried out in an environment of no smoking and no smell, thus the device having excellent safety and environmental protection property.
4 The split treater of the key equipment for this achievement has a horizontal integrating revolving structure, and comparing this structure with the bygone old equipment, it is found the fuel for the new equipment is fuel oil, and the residue generated in the burning course of fuel oil can fully reach to the exhaust discharge standards of all countries in the world, thus it being able to be used in any countries.
5 High effective fuel gas heat ing system: when the temperature of the heated gas reaches to 150, a large amount of gases----methane to butane---that cannot be fluidified in common temperature and pressure will be generated. And these gases can generate a large amount of heating energy after being burned fully in our specially designed gas burner, thus saving energy to a large degree.
6 The latest technology and the whole split and oil product collecting system developed by the company can be used for this device, and the produced fuel oil has some advantages such as high quality and high oil output rate.
Brief introduction
High efficiency, energy saving, big handling capacity, convenient installation, environment protection
Get more profits from waste plastic refining
The traditional refinery equipment named earth burner in China now adopts horizontal fixed treater. The technological process is as below: first manually feed the waste engine oil and raw oil extracted from waste plastics and scrap rubber from the top of split treater, then seal up the feed inlet and heat up slowly the bottom of treater with coal of fuel; the volume of a split treater usually is 20 stere, plus15 tons of material, and usually the smelting completes in two weeks. After the smelting is over, stop for 12 hours to make the treater fully cool down, then open the dregs outlet at the bottom of treater to discharge dregs, feed material from the feed inlet of treater to continue another cycle of refining.
the processing flow of Waste oil recycling machine
Technological Process
Pump the raw oil for further processing into reboiler, catalyst and heat in a decompression state to distillate oil vapour, make the oil vapour pass the condenser, then the part that can be liquefied will be condensed into oil product, and the part that cannot be liquefied will be sent into air heater for burning.
the processing 3D DRAWING of Waste oil recycling machine
Applicable Products & Industries of Oil Refining Treater
1. Raw oil extracted from waste plastics and scrap rubber
2. Waste engine oil
3. Waste raw oil
4. Waste washing oil
Analysis of Economic Benefit
1. Technical parameter of equipment
| Serial No. | Items | ||
1 | Equipment type | ZL-2 type | ||
2 | Raw material | Raw oil Waste engine oil Waste plastic oil Waste rubber oil | ||
3 | Structural form | Vertical band tower | ||
4 | 24-hour disposal amount (no less than) | 50 tons raw material | ||
5 | Working form | continuous operation | ||
6 | Operating pressure | Normal/ Negative pressure | ||
7 | Oil yield (No less than) | 85-90% | ||
8 | Power | 120.0kw | ||
9 | Mode of cooling | Water cooling | ||
10 | Consumption of cooling water (T/h) | 50 TONS | ||
11 | Heating mode | Hot air | ||
12 | Mounting means | Having base | ||
|
|
|
|
|
