Click for original picture
Legal status confirmed
Brand:aa
Product detail:
The technological process is as below: first manually feed the waste engine oil and raw oil extracted from waste plastics and scrap rubber from the top of split treater, then seal up the feed inlet and heat up slowly the bottom of treater with coal of fuel; the volume of a split treater usually is 20 stere, plus15 tons of material, and usually the smelting completes in two weeks. After the smelting is over, stop for 12 hours to make the treater fully cool down, then open the dregs outlet at the bottom of treater to discharge dregs, feed material from the feed inlet of treater to continue another cycle of refining.
the processing flow
the related data:
Equipment type | JL-1 type | JL-2 type | JL-3 |
Raw material | Raw oil Waste engine oil Waste plastic oil Waste rubber oil | Raw oil Waste engine oil Waste plastic oil Waste rubber oil | Raw oil Waste engine oil Waste plastic oil Waste rubber oil |
Structural form | Vertical band tower | Vertical band tower | Horizontal band tower |
24-hour disposal amount (no less than) | 6 tons raw material | 10 tons raw material | 25 tons raw material |
Working form | Intermittent operation | Intermittent operation | intermittent operation |
