RTV-2 Molding Silicones Rubber Material

Brand:aa

Product detail:

Introduction of RTV-2 Molding Silicones Rubber Material 

 

RTV-2 Molding Silicones Rubber Material is a kind of two-component material, the rtv-2 silicones rubber consists of Part A base silicones and Part B CA30 curing agent, and Part A base silicones and Part B curing agent can cure at room temperature by a condensation reaction to become a silicones mold. These materials can be cast into the cured silicones molds to duplicating : plaster polyurethane, PU, GRC, cement, resin, polyester, wax etc...

 

Specifications of MC RTV-2 Silicone Rubber

  

Equiped with REACH certificate 

Professional technician with rich experience 

4% catalyst is offered for free of charge  

Silicone range:10-60 shore A  

High duplicating silicone molds 

 

Applications of RTV-2 Molding Silicones Rubber Material 

    

MC RTV-2 Molding Silicones Rubber Material can be used in the field of reproducing cement molding, concrete stones, plaster molding, figures, art objects, decoration molding, GRC products, gypsum products, resin products, PU molds. Etc.

 

    

Storage ofv RTV-2 Molding Silicones Rubber Material 

 

When the RTV-2 Molding Silicones Rubber Material is stored at or below 30 °C(85 °F) in the original unopened containers, RTV2 Silicones Base and CA30 Curing agent have a usable life of 10 months from the date of production. After 10 months,please use a stockpile to stir the Part A silicones for some minutes, then the silicones rubber can be use again, no influence for other performance.

 

 

FOQ of RTV-2 Silicone Rubber for Mold Making

 

 

Why does the RTV liquid silicone rubber for molding have few mold making times?

 

The silicone rubber mold has few molding times is due to follwoing reasons: adding too much silicone oil which will destroy the molecular of silicone rubber; making the mold for small and fine detailed products with higher hardness silicone rubber which is easy to break; making the mold for large products with soft silicone rubber which will reduce the tensile and tear strength of the mold, and the mold will have deformation. Thus, we should take the proper silicone rubber to make the mold for suitable products.

 

 

  

The information above is just for reference, if you're interested or have any questions, please feel free to contact Nicole:

Web:www(dot)mcsilicone(dot)com

E-mail:nicole(at)mcsilicone(dot)com

Skype:nicoleszmc

MSN: nicoleszmc (at)hotmail(dot)com