promotion professional newest waste tyre recycling machine

Brand:aa

Product detail:

waste tyre recycling equipment

Physic mechanical crushing method at normal temperature of waste tyre:no chemical raw material is required,no waste gas,waste water and soot are discharged, 

and the cooling water of the equipment is reused,no emission,equipment noise is within the range specified by the country(GB20055-2006),fineness of rubber powder produced by it is adjustable(10 meshes to 30 meshes),take waste tyre as example,the process is as follows:breaking down,crushing,filtering,magnetic separating,grin-ding,then the finished products are produced.

 

Features of rubber recycling machinery

1.To granulate radial tires into fine rubber crumb of 40~120 mesh with steel and fiber completely recycled at ambient temperature.

2.The input is whole tires,after the processing,steel is completely separated and fiber can be separated up to 99% or above.The finish product is high and competitive in the market

3.Tight construction, small space and simple technique flow.

4. Low energy-consuming and good performance-cost ratio

5.Hight automatization, fewer labours requirement.

6.Reasonable construction,easy operation and low rate of breakdown

7.Environmental-protection,no pollution(no waste gas,no waste residue,no polluted water),meeting the environmental requirement of the government.

1.Tyre bead ring cutting off machine
This machine main to cut the inner dimater of the tyre, and cut the side of the tyre to the next step of segmentation.

Power	Blades rotating speed	Adapt tire	Productivity	Dimensions	Weight
3kw	15R/MIN	650-1200	30strips	1150*850*1200	0.5t

3.Specifiction: 

Model	Drum diameter	Drum length	Front roll linear speed	Roll speed ratio	Max roller spacing	Motor power	Daily capacity
XKP-350	300mm	500mm	17.6m/min	1:1.38	10mm	22kw	2tons
XKP-400	400mm	600mm	21.6m/min	1:1.38	10mm	30kw	4tons
XKP-450	450mm	760mm	25.3m/min	1:1.39	10mm	37/45kw	6tons
XKP-560	560mm	800mm	28.6m/min	1:1.41	10mm	55/60kw	8tons

 

Specification

1.The machine is used for cutting the used tires into tread and crown.

2. such cutting procedure is one part of rubber cutting line.

 Main parameters:

Model	Processing range	Equipped with power	Motor power	Production	Weight	Dimension
QKF850	900~1200mm tires	three-phase four-wire 380V  50HZ	2.2KW	40~60 pieces/hour	about 300KG	1300*900*1480(L*W*H)

Specifications

1.The machine is used for cutting the hard waste wires which have been processed into strips, then decompose them into block which are 3~5cm.

2.Such cutting procedure is one part of rubber cuttting line.

Main parameter:

Model	Processing range	Equipped with power	Motor power	Production	Normal life	Weight	Dismension
QK240	tire article and rubber article in 30~50mm	three-phase four-wire   380V  50HZ	7.5kw	7~12tons\shift	about 100tons steel wire tire	about 450kg	800*810*1070mm (L*W*H)

waste tyre recycling equipment factory welcome you to come .it is you best choice