product description:

BLS - Ⅱ - 8 l double cone tower low resistance, high wet dust removal equipment and KFX - Ⅰ type fast muddy water separator according to several water dust removal in use existing problems, to adapt to all kinds of sintering method, to adapt to all kinds of bad conditions, and overcome the other water dust removal can't g for hard water filter.

product features:

1, with double cone tower dust, mud not contact, prevent the sticky ash is simulated by plugging.

2, sprinkler head into dust outside area, method and nozzle shall not contact, solve the water spray nozzle blockage because of the influence and effect of dust collection problem.

3, the twin towers directly mounted on the shaft kiln two chimney, avoid the flue gas walk curve road caused by resistance, so the equipment resistance is low, need not use induced air also won't produce pour anti-smoking phenomenon.

4, with large water and dust removal, to speed up the water, so that water temperature is low, can solve pipe structure, reduce the water evaporation, and dust removal result is bad.

5, all of the use of circulating water, absolutely not to kiln of emissions and waste water.

6, dust back out of the sewage can through the muddy water separator will mud and water fast separation open, separate out of the mud with porridge paste continuous row to twin screw mixer, and does not need any special equipment mud, mud recovery 100% recycling, no line to the ground and cause the secondary pollution.

7, equipment operating cost is low, the power consumption is only 9 kw.

8, less investment, compared with the prices of similar products with low investment 100000 yuan/table. Therefore, this technology in the very great degree is superior to the existing various forms of water filter, and make sure the dust removal effect, flame kiln dust emission concentration of no more than 150 mg/m3, dying fire kiln of no more than 100 mg/m3.

technical parameters:

1, the processing capacity of 30000-60000 m3 / h;

2, allow dust concentration within fifty g/m3,

3, the dust removal efficiency was 99.6%; Dust emission concentration is lower than the national second area standards;

4, sewage handling capacity and m3 / h;

5, water consumption 0.2 m3 / h;

6, power consumption and kw, need to induced air as 31 kw;

7, discharge mud moisture content 50%;

Eight, after treatment can remove sulfur dioxide above 50%;

9, circulating water utilization rate 100%;

10, recycling material utilization rate 100%;

11, the equipment investment is $500000 to $/ sets.