CDL/CDLF Stainless Steel Vertical Multistage Centrifugal Pump
Pump Description
CDL / CDLF is a kind of vertical non-self priming multistage centrifugal pump, which is driven by a standard electric motor. The motor output shaft directly connects with the pump shaft through a coupling. The pressure-resistant cylinder and  are fixed between pump head and inlet &outlet section with stay bolts. The inlet and outlet are located at the pump bottom at the same plane. This kind of pump can be equipped with an intelligent protector to effectively prevent it from dry-running, out-of-phase and overload

Operation conditions
1)Thin, clean, non-flammable and non-explosive liquid containing no solid granules and fibers. 
2) Liquid temperature:
Normal temperature type:-15℃~ +70℃
Hot water type:-15℃~ +120℃
3)Ambient temperature: up to +40℃
4)Altitude:up to 1000m

Performance Range:
Capacity: 2 up to 500 m3/h

Head: 15 up to 195 m

Efficiency : 72% up to 92.5%

Rotation Speed: 2900 r/min

Power: 0.37 up to 15 kw

NPSH: 1.8

Special demands can be negotiated.  

Application:
CDL / CDLF is a kind of multifunctional products.It can be used to convey various medium from tap water to industrial liquid at different temperature and with different flow rate and pressure. CDL type is applicable to conveying non-corrosive liquid, while CDLF is suitable for slightly corrosive liquid.

 1) Water supply: Water filter and transport in Waterworks, boosting of main pipeline, boosting in high-rise buildings.
2)Industrial boosting: Process flow water system, cleaning system, high-pressure washing system, fire fighting system.
3)Industrial liquid conveying: Cooling and air-conditioning system, boiler water supply and condensing system,machine-associated purpose, acids and alkali.

4)Water treatment: Ultra filtration system,reverse osmosis system,distillation system, separator, swimming pool 

5)Irrigation: Farmland irrigation, spray irrigation, dripping irrigation. 

Motor
1. Full-enclosed air-blast two-pole standard motor
2. Protection class: IP55
3. Insulation class: F
4. Standard voltage:50Hz: 1 x 220-230 / 240V
                                           3 x 200-220 / 346-380V
                                           3 x 220-240 / 380-415 V
                                            3 x 3 80-415 V 

Performance curve
Following conditions are suitable for the performance curves shown bellow:
1.All curves are based on the measured values of 50Hz: constant motor speed 2900rpm or 2950rpm.
2.Curve tolerance in conformity with 1SO9906 Annex A.
3.Measurement is done with 20℃air-free water. kinematic viscosity of mm2/sec.
4.The operation of pump shall refer to the performance region indicated by the thickened curve to prevent overheating due to too small flow rate or overload of motor due to too large f1ow rate.
Website: http://www.sop-pump.com
Chaarsw@sogpump.com