1 fully assembled, tested and tuned Reprap 3D printer

2 pounds of ABS filament (CHOOSE BETWEEN NATURAL, BLACK, RED, ORANGE, BLUE & GREEN)
Firmware already loaded into the electronics board (Marlin)
Power cord (integrated)
USB cable
3oz bottle of 3-IN-ONE motor oil (for lubricating the shafts)
Setup instructions
1 month of tech support
WARRANTY: 1 YEAR FOR ALL COMPONENTS

clean design and safer environment, especially for children)
Lulzbot Budaschnozzle -or- J-Head hot-end/Wade's extruder for 3mm filament with a 0.5mm nozzle
Aluminum extruded frame (high rigidity for minimal vibration)
Heated build platform (warp-free printing with ABS or PLA)
Kapton-tape wrapped glass build surface (for excellent adhesion and super flat print surface)
Sanguinololu electronics board with Pololu stepper drivers (efficient and compact design)
High-torque NEMA 17 motors (x5)
Mechanical end-stops on all 3 axes
ABS printed parts (full black)
Approximately 200x200x170mm print volume
Print speeds of over 100mm/s (Many variables, including environment and plastic quality, effect this, so your speeds may vary.  If printing for the first time, I recommend a setting of 50mm/s.)